Detailed guide to home sink installation: teach you step by step how to install and what to pay attention to

Step 1: Measure and prepare

Use a measuring tool, such as a tape measure, to measure exactly where to install the sink. Mark the centerline and four corners of the sink.
If you already have an old sink, remove it first and clear the installation area. Make sure it is clean and free of residue.
Step 2: Install brackets or support structures

Depending on the type and design of the sink, install brackets or support structures. This ensures that the sink remains stable during use.
Step 3: Connect the water pipe

Use a pipe wrench to connect the sink's hot and cold water supply pipes to the faucet. Make sure to tighten and use appropriate fittings and seals.
To prevent leaks, seal joints with pipe sealant.
Step 4: Connect the drain pipe

Connect the sink drain line to the sewer or drainage system. Make sure the drain pipes are clear and not clogged.
Use a pipe wrench to tighten the drain pipe connection.
Step 5: Install the sink

Carefully place the sink into its stand or cabinet. Make sure the bottom of the sink is flush with the bracket.
Before installing a sink, make sure there is insulation on the bottom of the sink to prevent damage to the bottom of the sink.
Step 6: Secure the sink

Use clamps, support rods, or appropriate set screws to hold the sink securely in place.
Check the sink's horizontal and vertical position carefully to make sure it's not tilted.
Step 7: Connect the faucet and accessories

Install the faucet and connect accessories such as spouts and shower heads according to the manufacturer's guidelines.
Make sure all connections are tight and there are no leaks.
Step 8: Check for leaks

Open the faucet and drain to check for leaks. If there is a leak, stop using it immediately and repair the problem.
Step 9: Clean and seal

Clean the sink and surrounding area to make sure there is no dirt or residue.
Use an appropriate sealant to seal the edges of your sink to ensure waterproofing and prevent water leakage.
Step 10: Final inspection

Finally, check the stability and functionality of the sink to make sure everything is functioning properly.
If everything looks good, proceed with the final cleaning and decorating.
Make sure to read the manufacturer's installation instructions and follow local building codes and safety standards before installing your sink. Installing a sink requires care and patience, and if you're unsure about any steps, consider hiring a professional plumber to do the installation.